Easter Magnetic Cut-off
Easter Magnetic cut-off Roller type Tumble dryers are widely used in food, feed, chemical, pharmaceutical, mining and other industries. The working process of the equipment is as follows: after the dehydrated wet material is added to the dryer, the material is uniformly dispersed in the dryer...
Easter Magnetic cut-off
Tumble dryers are widely used in food, feed, chemical, pharmaceutical, mining and other industries. The working process of the equipment is as follows: after the dehydrated wet material is added to the dryer, the material is uniformly dispersed in the dryer and fully contacted with the hot air in the dryer, and the drying heat transfer and mass transfer are accelerated. In the drying process, the material is discharged under the action of the inclined plate and the hot temper, and the star discharge valve is discharged to the other part of the dryer. The machine is suitable for the drying of various kinds of slag materials with water content less than 85%, such as beer waste, bean dregs, sprayed corn husk, coal slime, pomace, etc., which has good effects on opening up feed resources, reducing feeding cost and reducing environmental pollution. In the past 10 years, the main export products of China's tumble dryers are vibration drying equipment, vacuum drying equipment, small and medium-sized grain, food and agricultural and forestry products drying equipment. The annual export volume exceeds several hundred. The main export area is Southeast Asia. And other developing countries, and has opened the door to the European and American markets. Principle Introduction The heat source of the tumble dryer comes from the combustion device and adopts a downstream heating method. Therefore, the material to be dried is slipped from the feed box and the feed into the cylinder, that is, pushed back by the spiral plate. As the dryer is placed obliquely, the material flows to the rear end under the action of gravity and rotation. On the other hand, the material is repeatedly picked up by the copying board, and is taken to the upper end and then continuously sown down, so that the material forms a uniform curtain in the cylinder. The curtain is fully exchanged with the hot air flow in the cylinder. As the material is repeatedly spread, the moisture contained is gradually dried, thereby achieving the purpose of drying. Operation method Open the door, rotate the material dehydrated by the dehydrator evenly in the drum, and then close the door. Depending on the type of material, select the appropriate time and adjust the timing device to the desired time. Press the start button to start the fan. According to the user's needs, the direction of rotation of the drum can be selected from one-way rotation and two-way rotation. As long as the computer board switch is turned to one-way or two-way, the machine will perform one-way operation or two-way operation as required. (Forward 25 seconds, stop for 5 seconds, reverse 25) Always look at the inversion of the internal fabric from the observation window. If unexpected conditions are found, the power should be cut off and the fault should be checked. When the machine runs to the specified time, the machine will automatically stop running. At this time, the operator must open the door to check the drying condition of the inner fabric. If the effect is not achieved, the time can be extended appropriately.
The main features are automatic control devices, which can be automatically completed by simply adjusting the time through the control panel. The drum is made of high quality stainless steel, and the barrel is beautiful and smooth, and durable. The processing capacity is large, the fuel consumption is small, and the drying cost is low. It adopts triangular tape transmission, which is stable in operation, low in noise, safe and reliable.